Installation Instructions for astroguard hurricane shutters
You will need:
AstroGuard Hurricane Fabric Panels
Clips and Hardware (purchased with AstroGuard)
Power hammer drill for concrete or standard drill for wood
Drill Bits: 7/16” and 1/2"
Driver Bit for anchor purchased
Cordless Screwdriver, Phillips head
Permanent Marker
Stepladder
STEP 1 ATTACH CLIPS: Double check which sides of the opening will need Clips. If top is being attached, start with the top. If not, start on the left side. Make a mark 2” from the corner. Using your tape measure, mark the other clip positions all the way across that side. Repeat for the other sides that will be attached. Remember to space clips at 12” apart, center-to-center, or use the proper clip spacing for your area. Attach the first clip. Put the top and bottom pieces of the clip together and slide the fabric in between the pieces until the edge of the fabric is even with the first notch. Using your cordless screwdriver, attach 8 screws to the clip as shown. Attach the remaining clips.
STEP 2 DRILL & HANG ASTROGUARD Hold the fabric over the opening, make sure it is centered. Using a permanent marker, place a mark in the upper Left hand corner where the first clip will be attached.
Using your Power Drill, drill a hole in that spot. Using the Driver Bit, install the anchor into the hole. Fasten the fabric on that side. Pull the fabric snug across the opening and mark the clip position on the other side. Do not over-tighten fabric. Drill holes and install hardware on other side. Attach fabric.
STEP 3 REMOVE FABRIC AND LABEL: Once the fabric has been properly installed, remove each piece and label the opening with a permanent marker, using the numbers from your house drawing.
STEP 4 STORAGE AND CLEANUP: AstroGuard can be folded and stored in storage bags. Always make sure the fabric is clean and dry before storage. You can clean AstroGuard with water and a mild soap, such as dishwashing liquid. For persistent stains, use OxiClean and a scrub brush.
If any chipping of the stucco occurred during installation, simply fill the hole with stucco patch, let dry and touch up with paint. You can also paint the AstroGuard hardware after it is installed so it blends nicely with your home.